Rev.1

[LarryTheWombat]

Aye Slider...i know uve prolly been asked this like 100000 times but how much $$$ would it cost me to build the Rev.1... Just tell me in US $ and ill double it...gosh darn exchange rate..its screwing us aussies over...Im too lazy too look through all the messages to find the answer so i thought id ask you straight out...

Cheers dude....

[slider]

Material between 400 to 600, depending on top surface used. I advise metal and metal mesh for all ramps. Labor depends on how good the shop is and how fast the worker is. Here I have been told it cost around 1,500 to have one built, labor only. If they bend the metal it should be cheaper but a radius will not work. Use my measurements almost exactly, within 1". (30mm?)

[LarryTheWombat]

Rev.1...good first ramp?
ure site says 50-65ft...thanx for the response

[crustyfmx250]

Originally posted by slider
Use my measurements almost exactly, within 1". (30mm?)

25.4 to be exact :D heh

and larry, id say its a fine 1st ramp, IF you are already at a fairly high skill level of jumping on dirt.

[WaussInd]

Slider... what's this about a radius?

If you bend the metal you can't have a flat spot??

Could you please explain this? (sorry), my friend and I are going to build a ramp in his welding class, and we were planning on bending the metal. I don't know anything about it, so i'm curious..

[NoFeAr FrEaK #101]

yeah if i got a ramp built i would just bend it i recon it would b easyer. would it???